GPLMUX43

Selection between GPIO and LoanIO output and output enable for GPIO43 and LoanIO43. These signals drive the Pin Mux. The Pin Mux must be configured to use GPIO/LoanIO in addition to these settings Only reset by a cold reset (ignores warm reset). NOTE: These registers should not be modified after IO configuration.There is no support for dynamically changing the Pin Mux selections.
Module Instance Base Address Register Address
sysmgr 0xFFD08000 0xFFD08680

Offset: 0x680

Access: RW

Important: To prevent indeterminate system behavior, reserved areas of memory must not be accessed by software or hardware. Any area of the memory map that is not explicitly defined as a register space or accessible memory is considered reserved.
Bit Fields
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16

Reserved

15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0

Reserved

sel

RW 0x0

GPLMUX43 Fields

Bit Name Description Access Reset
0 sel
Select source for GPIO/LoanIO 43.
Value Description
0x0 LoanIO 43 controls GPIO/LOANIO[43] output and output enable signals.
0x1 GPIO 43 controls GPIO/LOANI[43] output and output enable signals.
RW 0x0